8. Slowly install bushing in bore using a 1/2-in. drive ratchet wrench with deep-well socket on double nut and a combination wrench to hold single nut. Protect cylinder head with a shop towel on wrench handle. 9. Remove alignment pin (A) from oil hole once bushing is started in bore. Continue tightening double nut until shoulder of installer contacts tower. RG8337 –UN–09DEC97 A—Alignment Pin Bushing Installation Alignment Pin CTM100 (06APR04) 02-050-23 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,196 –19–25OCT00–5/7 040604 PN=263 Camshaft and Timing Gear Train 3. Position installer and sleeve with bushing on the front side of No.
1 tower with alignment groove (A) in guide sleeve positioned approximately as shown. 4. Install 313793 Forcing Screw with washer through installer with double nut towards front of engine. –UN–09DEC97 5. Install JDG968-3 Guide (B) in the rear of tower No. 2 with 313793 Forcing Screw through guide. Secure assembly (finger tight) with nut and washer. RG8335 6. Install large end of JDG968-5 Alignment Pin (C) into oil hole (spring pin removed) until pin engages groove in Positioning Bushing and Installer in Head alignment sleeve. 7. Once pin engages groove, rotate sleeve toward valves until you feel a positive stop.
This ensures that the oil holes in bushing and cylinder head will be properly aligned after installation. –UN–09DEC97 A—Alignment Groove B—JDG968-3 Guide C—JDG968-5 Alignment Pin RG8336 Indexing Bushing in Head RG,RG34710,196 –19–25OCT00–4/7 02 050 23