CTM100 (06APR04) 02-050-27 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=267 Camshaft and Timing Gear Train SAE “B” Rear Auxiliary Drive Disassemble Rear Auxiliary Drive Assembly NOTE: Refer to CTM67, OEM Engine Accessories, for repair of auxiliary drive assembly. –UN–30OCT00 1. Remove rear auxiliary drive assembly (G) from front plate. Discard O-ring (B). RG11166 2. Support front face of adapter housing (A). Press gear (F) and bearing (E) out of housing bore. SAE “B” Rear Auxiliary Drive Assembly 3. Remove snap ring (C) from gear shaft. Discard snap ring. 4. Remove bearing from gear. Discard bearing. 5. Thoroughly clean and inspect gear and housing.
–UN–30OCT00 Assemble Rear Auxiliary Drive Assembly 1. Assemble bearing onto gear shaft. Press bearing flush with shoulder on gear. RG11167 2. Determine correct size snap ring (C) and shim (D) (if SAE “B” Rear Auxiliary Drive required) to achieve 0.11 mm (0.004 in.) maximum clearance between bearing cone and snap ring. See A—SAE “B” Adapter Housing parts catalog for snap ring and shim sizes. B—O-Ring C—Snap Ring1 D—Shim1 3. Support back side of adapter housing. Press gear and E—Bearing bearing assembly into housing until assembly bottoms. F—Splined Gear G—Rear Auxiliary Drive Assembly IMPORTANT: Make sure oil drain port (H) is H—Oil Drain Port positioned on bottom as shown. 4.
Install assembly onto front plate using a new gasket. Tighten cap screws to specifications. Specification SAE “B” Rear Auxiliary Drive Adapter—Torque........................................................... 110 N•m (81 lb-ft) 1Three snap ring sizes and one shim size are available to set gear shaft end play. See parts catalog for sizes and part numbers. RG,RG34710,198 –19–26OCT00–1/1 02 050 27