Delphi — Install Oil Cooler/Oil Filter Valve Housing Assembly or Oil Cooler Cover/Valve Housing Assembly

CTM100 (06APR04) 02-060-9 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=277 Lubrication System 4. Install oil filter/valve housing (or oil cooler cover/valve housing on remote applications) using a new gasket. Tighten cap screws to specifications using sequence shown in lower illustration. Specification Oil Filter/Valve Housing or Oil –UN–21MAY98 Cooler Cover/Valve Housing1— Torque............................................................................. 68 N•m (50 lb-ft) 5. Retighten cap screws to specification using same RG8247 sequence.

Install Filter and Valve Housing Specification Oil Cooler Housing-to-Block Cap Screws—Retorque........................................................... 68 N•m (50 lb-ft) 6. Tighten coolant pump-to-oil cooler housing hose clamps securely. 7. Coat oil filter gasket with clean engine oil. Install filter to housing until gasket contacts base, then tighten an additional 1/2—3/4 turn. 8. If equipped with a remote filter: Connect hose or line ends to oil cooler cover/valve housing and tighten hose –UN–20MAY98 or line ends to specification. Specification Remote Filter Inlet Hose or Line—Torque...............................................................

190 N•m (140 lb-ft) RG8815 Remote Filter Outlet Hose or Line—Torque............................................................... 142 N•m (105 lb-ft) Oil Filter Housing Torque Sequence 9. Install turbocharger oil inlet line onto housing adapter and tighten to specifications. Specification Turbocharger Oil Inlet Line-to-Oil Cooler Housing—Torque................................................. 35 N•m (26 lb-ft) 1Torque sequence and specification also applies to oil cooler cover/valve housing on remote filter applications. RG,RG34710,213 –19–24SEP02–2/2 02 060 9