Clean and Inspect Oil Pump and Drive Gear IMPORTANT: DO NOT disassemble oil pump for repair or inspection. No repair parts are available. Replace pump as a complete assembly as necessary. 3. Inspect back side of oil pump cover through cavities for evidence of gear contact with cover. Replace pump if gear contact is noticed. 1. Completely flush oil pump with solvent while rotating input shaft by hand to clean any debris from housing and gears. 4. Inspect oil pump drive gear teeth for wear. Inspect and measure drive gear bushing ID. Bushing ID must be within specifications. Replace drive gear and bushing assembly as necessary. 2.
Using a good light source, look through rear cavities of pump to inspect all gear teeth for abnormal wear. Replace pump if excess wear is noticed. Specification Oil Pump Drive Gear Bushing— ID 135.70—135.80 mm (5.343—5.346 in.) ........................................................................ RG,RG34710,215 –19–13AUG99–1/1 CTM100 (06APR04) 02-060-11 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=279 Lubrication System 5. Remove oil pump-to-cylinder block gasket (B). Discard gasket. A—Oil Pump Assembly B—Oil Pump-to-Cylinder Block Gasket –UN–06DEC97 RG8258B Oil Pump Removed RG,RG34710,214 –19–25OCT00–3/3 02 060 11