Lubrication System Install Engine Oil Pump 1. Position new gasket (A) in oil pump bore on front face of cylinder block. 02 060 2. Apply TY6333 or TY6347 High Temperature Grease to inside cavities of oil pump through openings in back of oil pump. 12 RG8258A –UN–06DEC97 IMPORTANT: Holes (B) in cylinder block, gasket and oil pump housing must align to ensure proper lubrication for oil pump-to-gear bushing. Installing Oil Pump NOTE: 101.6 mm (4.0 in.) long guide pins may be used to aid oil pump cap screw hole alignment, if desired. Cap screw holes will be aligned only when oil pump is correctly installed. 3. Install oil pump on cylinder block.
Apply LOCTITE 242 (TY9473) Thread Lock and Sealer to oil pump-to-cylinder block cap screw threads and tighten to initial torque specification. RG8259 –UN–06DEC97 Specification Oil Pump-to-Block Cap Screws— Initial Torque 20 (177 lb-in.) ................................................................. Oil Pump Gasket A—Gasket B—Lubrication Holes LOCTITE is a registered trademark of Loctite Corp. Continued on next page RG,RG34710,216 –19–24SEP02–1/2 CTM100 (06APR04) 02-060-12 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=280