Remove Engine Oil Pan 1. Disconnect turbocharger oil inlet line. Remove oil pan drain plug and drain all engine oil. NOTE: It may be necessary to tap oil pan with a rubber or plastic dead-blow hammer to free oil pan from gasket seal. RG8819 –UN–20MAY98 2. Remove all 30 oil pan cap screws and remove oil pan from cylinder block. 3. Remove all gasket material from oil pan and cylinder block gasket sealing surfaces. Removing Oil Pan 4. Clean all oil from oil pan and cylinder block sealing surfaces and dry completely. CTM100 (06APR04) 02-060-13 P OWER T ECH 10.5 L & 12.5 L Diesel Engines RG,RG34710,217 –19–30SEP97–1/1 040604 PN=281 Lubrication System 4. Second:
Starting with first cap screw tightened, apply 90° torque turn to each cap screw. Specification Oil Pump-to-Block Cap Screws— Torque Turn.......................................................................... 90° (1/4 Turn) –UN–30AUG02 5. Rotate input shaft full 360° after pump installation. If shaft does not turn freely for full 360°, remove pump and determine cause. RG12611 6. Apply TY6333 or TY6347 High Temperature Grease to ID of oil pump drive gear bushing. 90° Torque Turn 7. Install oil pump gear with bushing over oil pump housing; align input shaft with opening in gear. 8. Install external snap ring in groove of input shaft. 9. Check oil pump drive gear-to-idler gear backlash.
–UN–21MAY98 Specification Oil Pump Drive Gear-to-Idler Gear—Backlash.......................................................... 0.25 mm (0.010 in.) RG8256 10. Install timing gear train cover and complete final assembly. (See INSTALL TIMING GEAR COVER in Installing Oil Pump Drive Gear Group 040.) RG,RG34710,216 –19–24SEP02–2/2 02 060 13