CTM100 (06APR04) 02-070-1 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=285 Group 070 Cooling System Replace Bearings in Fan Drive Assembly –UN–17SEP02 RG12423 Fan Drive Exploded View A—Fan Hub/Pulley C—Snap Ring F—Bearing Housing (Fixed)1 H—Pipe Plug B—Grease Seal D—Ball Bearing (2 used) G—Bearing Housing I—Plug E—Shaft (Adjustable) Disassemble Fan Drive 4. Remove pipe plug (H) or plug (I), grease seal (B), and snap ring (C). Discard seal and snap ring. 1. Remove V-belts and remove fan. 5. Remove shaft with bearings (D) by lightly tapping 2. Using a suitable puller, remove fan hub (A) from end of shaft (through pipe plug opening) with a shaft (E). hammer and brass drift. NOTE:
ON engines with fixed fan drive assembly cast 6. Remove bearings from shaft using a bearing puller. into camshaft gear access cover, cover must Discard bearings. be removed from engine. (See REMOVE TIMING GEAR COVER in Group 040.) 7. Thoroughly clean and inspect shaft and bearing housing (F or G) for cracks or any other damage. 3. Remove fan drive assembly from engine. Measure parts and compare with specifications given below. NOTE: Early adjustable bearing housings (G) will use threaded type pipe plug (H). Fixed bearing housings (F) and later adjustable bearing housings (G) will use press in type plug (I). 1 Bearing housing is cast into camshaft gear access cover.
Continued on next page RG,RG34710,224 –19–17SEP02–1/5 02 070 1