Lubrication System NOTE: Locate rear of oil pan flush to ± 0.05 mm (0.002 in.) with rear face of cylinder block. 5. Carefully install oil pan on cylinder block and tighten all oil pan-to-cylinder block cap screws in sequence shown to specifications. Start at right rear corner of oil pan (facing toward flywheel end) and proceed counterclockwise according to the sequence. 02 060 16 Specification Oil Pan-to-Cylinder Block Cap Screws—Torque 25 (18.5 lb-ft) plus 90 ° Turn Clockwise .................................... 6. Tighten oil pan-to-rear oil seal housing and oil pan-to-timing gear cover cap screws to specification.
Specification Oil Pan-to-Rear Oil Seal Housing Cap Screws—Torque 25 (18.5 lb-ft) plus 90 ° Turn Clockwise ............................ Oil Pan-to-Timing Gear Cover Cap Screws—Torque 25 (18.5 lb-ft) plus 90 ° Turn Clockwise ............................ 7. Install oil pan drain plug using a new O-ring and tighten to specifications. Specification Oil Pan Drain Plug 1-1/4 in. Hex Plug—Torque 46 (34 lb-ft) ................................................................... Oil Pan Drain Plug 1-1/2 in. Hex Plug—Torque 64 (47 lb-ft) ................................................................... RG8817 –UN–20MAY98 8.
If equipped, coat threads of drain hose and drain valve with LOCTITE 592 Pipe Sealant with TEFLON . Install and tighten securely. Oil Pan Torque Sequence LOCTITE is a registered trademark of Loctite Corp. TEFLON is a registered trademark of Du Pont Co. RG,RG34710,219 –19–24SEP02–2/2 CTM100 (06APR04) 02-060-16 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=284