Delphi — Install Engine Oil Pan

CTM100 (06APR04) 02-060-15 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=283 Lubrication System Install Engine Oil Pan NOTE: When installing the oil pan gasket and pan, ensure that the oil pan bolts are installed loosely (leave approximately 1/4 inch gap between the pan and block pan rail).This will allow the gasket –UN–03APR02 to center itself to the bolt and block pattern. Once the bolts are installed, follow the torque sequence defined later in this group. RG10273A All oil pan and cylinder block gasket sealing surfaces (including timing gear cover and rear seal housing) MUST BE free of gasket material and oil. Surface must be dry. 1.

Apply LOCTITE 7649 Solventless Primer to two front T-joint areas (A). At close to 5 minutes, apply a 3 mm (1/8 in.) bead of LOCTITE 17430 High Flex Form-In-Place Gasket. –UN–06AUG99 2. Apply a 3 mm (1/8 in.) bead of LOCTITE 17430 High Flex Form-In-Place Gasket to two rear T-joint areas (C), and on inside edge of both cap screw holes for rear oil seal housing. RG10274 3. Position new oil pan gasket on cylinder block. Sealant Applications—Rear Rail 4. Apply a 3 mm (1/8 in.) bead of LOCTITE 17430 High A—Front T-Joints Flex Form-In-Place Gasket to face of oil pan gasket at C—Rear T-Joints same T-joint locations (A) and (C) on cylinder block in steps 1 and 2 above.

LOCTITE is a registered trademark of Loctite Corp. Continued on next page RG,RG34710,219 –19–24SEP02–1/2 02 060 15