CTM100 (06APR04) 02-070-3 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=287 Cooling System –UN–17SEP02 RG12423 Fan Drive Exploded View A—Fan Hub/Pulley C—Snap Ring F—Bearing Housing (Fixed)1 H—Pipe Plug B—Grease Seal D—Ball Bearing (2 used) G—Bearing Housing I—Plug E—Shaft (Adjustable) Assemble Fan Drive Specification Fan Drive Shaft—End Play................................. 0.10 mm (0.004 in.) 1. Pack inner and outer bearings (D) with TY6333 or 6. Install snap ring in housing groove. Visually inspect TY6347 High Temperature Grease. Apply clean snap ring installation for proper seating in housing engine oil to bearing ID and shaft OD groove. 2.
Support end of shaft (E) and install bearings NOTE: Install grease seal (B) with seal spring toward against shoulder on each end of shaft. Apply force engine. to bearing inner race only. 7. Apply a thin coat of clean engine oil to OD of seal 3. Support bearing housing (F or G) on a firm flat casing (B) and to seal lips. Using a driver that surface with bearing bore in the upward position. contacts flat outside case of seal, press seal in housing bore until metal casing is flush to 0.50 mm 4. Install bearing and shaft assembly into housing (0.020 in.) below housing face. using JDG743A Bearing Driver. Small end of shaft should extend through housing. 5.
Determine proper snap ring (C) thickness needed to obtain specified end play. 1 Bearing housing is cast into camshaft gear access cover. Continued on next page RG,RG34710,224 –19–17SEP02–3/5 02 070 3