Delphi — Replace Bearings in Fan Drive Assembly

Cooling System IMPORTANT: On engines with fixed pulleys, be sure the lower right access cover cap screw (3, in diagram on this page) is installed in the camshaft gear access cover before the pulley (A, figure on previous page) is pressed on. Otherwise, pulley will interfere with installation of this cap screw. 02 070 4 8. Apply clean engine oil to ID of fan hub/pulley (A, figure on previous page). Support end of shaft through pipe plug hole in bearing housing. Using a driver that bears on outside finished edge of hub, press hub onto other end of shaft until it bottoms against shoulder. Do not hammer fan hub onto shaft. RG8811 –UN–20MAY98 9. Install washer and cap screw.

Tighten cap screw to specifications. Specification Fan Drive Hub-to-Shaft—Torque 115 (85 lb-ft) .................................. Camshaft Gear Access Cover On engines with dual pulleys, tighten pulley-to-pulley cap screws to the following specifications. Specification Fan Pulley-to-Pulley Cap Screws—Torque 61 (45 lb-ft) .............................................................. 10. On fixed fan drive and later adjustable fan drive assemblies, plug (I, figure on previous page) should be driven in flush to slightly recessed in rear surface of camshaft gear access cover. 11.

On early adjustable fan drive assemblies, apply LOCTITE 592 Pipe Sealant with TEFLON (TY9480) to threads of pipe plug (H, figure on previous page). Install and tighten plug in bearing housing. 12. Install adjustable fan drive assembly onto engine and tighten cap screws to specifications. Specification Adjustable Fan Drive-to-Camshaft Gear Access Cover Cap Screws—Torque 90 (66 lb-ft) .............................................................. LOCTITE is a registered trademark of Loctite Corp. TEFLON is a registered trademark of Du Pont Co. CTM100 (06APR04) 02-070-4 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,224 –19–17SEP02–4/5 040604 PN=288