CTM100 (06APR04) 02-070-15 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=299 Cooling System Specification Coolant Temperature Sensor— Torque............................................................................ 10 N•m (7.5 lb-ft) Thermostat Housing Pipe Plugs— Torque............................................................................. 20 N•m (15 lb-ft) RG,RG34710,235 –19–17SEP02–2/2 02 070 15 Remove and Install Coolant Heater—if Equipped CAUTION: To avoid shock or hazardous operation, always use a three-wire heavy-duty electrical cord. If a two-to-three contact adapter –UN–23AUG88 is used at the wall receptacle, always connect green wire to a good ground.
Keep electrical connectors clean to prevent arcing. TS210 Only plug coolant heater into electrical power if heating element is immersed in coolant. Testing Coolant Heater Otherwise sheath could burst, causing personal injury. 1. Unplug heater from electrical power source. 2. Partially drain cooling system. 3. Remove electrical cord (A), loosen nut, and pull heater element (B) out of oil cooler housing. NOTE: The heater element cannot be repaired. If defective, replace it. 4. Apply LOCTITE 592 Pipe Sealant with TEFLON (TY9480) to coolant heater threads. 5. Install heater element in oil cooler housing and tighten hex nut securely. 6. Install cord.
–UN–11AUG99 A—Electrical Cord B—Heater Element RG8472 Engine Coolant Heater LOCTITE is a registered trademark of Loctite Corp. TEFLON is a registered trademark of Du Pont Co. RG,RG34710,236 –19–30SEP97–1/1