Delphi — Remove and Install Thermostat Housing

Cooling System Remove and Install Thermostat Housing Remove Thermostat Housing 02 070 1. Disconnect top liner cooling return line (B) from thermostat housing. 14 2. Remove three cap screws (A) securing thermostat housing to cylinder block. RG8239C –UN–05DEC97 3. Pull thermostat housing straight out from engine to free housing from top liner cooling outlet adapter (C). Thermostat Housing Installed 4. Loosen hose clamp and remove hose from housing nipple. 5. Remove gasket and discard. Clean all gasket material from mounting surfaces. Install Thermostat Housing RG8241 –UN–05DEC97 1. Apply clean engine oil to top liner cooling outlet adapter O-ring. 2.

Position thermostat housing on engine using a new gasket. Be sure housing is firmly seated on top liner cooling adapter O-ring. Thermostat Housing Removed 3. Install mounting cap screws and tighten to specifications. A—Cap Screws (3 Used) B—Return Line C—Outlet Adapter Specification Thermostat Cover/Housing Assembly-to-Block Cap Screws— Torque 50 (37 lb-ft) ............................................................................. 4. Connect top liner cooling return line and tighten securely. 5. If removed, apply LOCTITE 592 Pipe Sealant with TEFLON (TY9480) to pipe plugs and temperature sensor and tighten to the following specifications. LOCTITE is a registered trademark of Loctite Corp.

TEFLON is a registered trademark of Du Pont Co. CTM100 (06APR04) 02-070-14 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,235 –19–17SEP02–1/2 040604 PN=298