Delphi — Remove Turbocharger

CTM100 (06APR04) 02-080-3 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=303 Air Intake and Exhaust System Remove Turbocharger CAUTION: After operating engine, allow exhaust system to cool before removing turbocharger. Thoroughly clean exterior of turbocharger and surrounding –UN–05DEC97 area to prevent entry of dirt into the air intake system during removal. IMPORTANT: When cleaning turbocharger, do not RG8187B spray directly into compressor cover or turbine housing. If turbocharger Removing Turbocharger inspection is required, do not clean exterior prior to removal. Doing so may A—Oil Inlet Line wash away evidence of a potential B—Oil Return Pipe failure mode.

See TURBOCHARGER SEVEN-STEP INSPECTION later in this group.) 1. Refer to your machine technical manual to disconnect air inlet and exhaust piping. 2. Remove turbocharger air intake hose and exhaust elbow. Remove turbocharger air outlet piping (shown removed). 3. Disconnect oil inlet line (A) and oil return pipe (B) from turbocharger. 4. Remove four mounting cap screws and lift turbocharger from exhaust manifold. Remove stainless steel gasket. 5. Place turbocharger on a clean flat surface. Cap or plug all air intake and exhaust openings. 6. Perform turbocharger seven-step inspection, as described later, if failure mode has not yet been determined.

See TURBOCHARGER SEVEN-STEP INSPECTION later in this group. RG,RG34710,241 –19–30SEP97–1/1 02 080 3