Delphi — Turbocharger Failure Analysis

Air Intake and Exhaust System Turbocharger Failure Analysis The following is a guide for diagnosing the cause of turbocharger failures after removal from the engine. 02 080 Problem Possible Cause Suggested Remedy 4 COMPRESSOR HOUSING INLET DEFECTS Foreign Object Damage Objects left in intake system. Disassemble and inspect intake system for foreign objects (this group). Inspect engine for internal damage. Leaking and/or defective intake system. Inspect air intake system connections including air filter; repair as required (this group). Inspect air intake related engine components. Compressor Wheel Rub Bearing failure.

Determine if engine and/or operator contributed to lack of lubrication, contaminated lubrication, excessive temperature, or debris generating engine failure in progress. Correct as required. Manufacturing defects. Correct as required. COMPRESSOR HOUSING OUTLET DEFECTS Oil and/or Dirt in Housing Restricted air intake system. Inspect and clean air cleaner. Prolonged periods of low rpm engine Check with operator to confirm conditions. (See idling. Operator’s Manual.) Defective oil seal ring. Repair as required (this group). Restricted oil drain line. Inspect and clear oil drain line as required. TURBINE HOUSING INLET DEFECTS Oil in Housing Internal engine failure.

Inspect and repair engine as required. Oil leaking from compressor housing Verify that oil is in compressor housing and refer to seal. “Compressor Housing Outlet Defects” as listed earlier in this chart. Center Wall Deteriorated Excessive operating temperature. Check for restricted air intake. Check engine for overfueling. Continued on next page OUO1004,0000C21 –19–29NOV00–1/2 CTM100 (06APR04) 02-080-4 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=304