CTM100 (06APR04) 02-080-5 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=305 Air Intake and Exhaust System TURBINE HOUSING OUTLET DEFECTS Turbine Wheel Rub Bearing failure. Determine if engine and/or operator contributed to lack of lubrication, contaminated lubrication, excessive temperature, or debris generating engine failure in progress. Correct as required. Manufacturing defect. Correct as required (this group). Foreign Object Damage Internal engine failure. Inspect and repair engine as required. Objects left in intake system. Disassemble and inspect air intake system (this group). Leaking air intake system. Correct as required (this group).
Oil and/or Excessive Carbon Internal engine failure. Verified by oil in turbine housing. Correct as required. Turbine seal failure. Inspect for excessive heat from overfueling and/or restricted air intake. Prolonged periods of low rpm engine Ask operator to run engine under load or at a higher idling. rpm. (See Operator’s Manual.) Restricted oil drain line. Inspect and clear oil drain line as required. EXTERNAL CENTER HOUSING AND JOINT DEFECTS Leaks from Casting Defective casting. Replace turbocharger (this group). Defective gasket. Verify if leaks are occurring at gasket joints. Leaks from Joints Loose attaching screws. Tighten to specifications in CTM (this group). Defective gasket.
Inspect and repair as required. INTERNAL CENTER HOUSING DEFECTS Excessive Carbon Build-Up in Housing Hot engine shutdown. Review proper operation with operator as shown in or on Shaft Operator’s Manual. Excessive operating temperature. Restricted air intake; overfueling or mistimed engine. Restricted oil drain line. Inspect and clean oil drain lines as required. Operating engine at high speeds and Idle engine for a few minutes to allow oil to reach loads immediately after start-up. bearings before applying heavy loads. OUO1004,0000C21 –19–29NOV00–2/2 02 080 5