Air Intake and Exhaust System Turbocharger Seven-Step Inspection The following inspection procedure is recommended for systematic failure analysis of a suspected failed turbocharger. This procedure will help to identify when a turbocharger has failed and why it has failed, so the primary cause of the failure can be corrected. Compressor Housing Outlet. Turbine Housing Inlet. Turbine Housing Outlet and Turbine Wheel. External Center Housing and Joints. Internal Center Housing. Turbocharger Bench Test. 02 080 6 Proper diagnosis of a non-failed turbocharger is important for two reasons.
First, identification of a non-failed turbocharger will lead to further investigation and repair of the cause of a performance complaint. NOTE: To enhance the turbocharger inspection, an inspection sheet (Form No. DF-2280 available from Distribution Service Center—English only) can be used that lists the inspection steps in the proper order and shows potential failure modes for each step. Check off each step as you complete the inspection and record any details or problems obtained during inspection. Retain this with the work order for future reference. Second, proper diagnosis eliminates the unnecessary expense incurred when a non-failed turbocharger is replaced.
The seven recommended inspection steps, which are explained in detail on the following pages, are: Compressor Housing Inlet and Compressor Wheel. DPSG,OUO1004,945 –19–28JUL99–1/13 Compressor Housing Inlet and Compressor Wheel 1. Check compressor inlet and compressor wheel (A) for foreign object damage. NOTE: Foreign object damage may be extensive or minor. In either case, the source of the foreign object must be found and corrected to eliminate further damage. RG4523 –UN–03NOV97 2. Mark findings on your checklist and continue the inspection.
Checking Inlet and Compressor Wheel A—Compressor Wheel Continued on next page DPSG,OUO1004,945 –19–28JUL99–2/13 CTM100 (06APR04) 02-080-6 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=306