CTM100 (06APR04) 02-080-13 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=313 Air Intake and Exhaust System Perform Radial Bearing Clearance Test This test will give an indication of the condition of the radial bearings within the center housing and rotating assembly. 1. Fasten a magnetic base (plunger-type) dial indicator to the turbocharger mounting base. Assemble an extension adapter and indicator extension rod onto dial –UN–20AUG99 indicator. 2. Position indicator tip (through center housing oil return) on center of shaft. Preload indicator tip and zero dial RG10284 on indicator. IMPORTANT:
Use only moderate hand force (3—4 Checking Radial Bearing Clearance pounds) on each end of shaft when checking clearance. 3. Grasp rotating shaft at both ends and move the shaft toward the indicator, then away from the indicator (arrows). Use care to move the shaft in the same direction as the dial indicator tip travels and apply equal pressure at both ends of the shaft. 4. Observe and record total indicator movement.
Specification Garrett Turbocharger Shaft— Radial Bearing Clearance (Allowable Movement)..........................0.076—0.165 mm (0.003—0.0065 in.) (measured on center of shaft) Borg Warner Turbocharger Shaft—Radial Bearing Clearance (Allowable Movement)............................ 0.56—0.81 mm (0.022—0.0.032 in.) (measured on end of shaft) If total indicator reading is not within specification, install a replacement turbocharger. DPSG,OUO1004,946 –19–03NOV00–1/1 02 080 13