Delphi — Turbocharger Break-In

Turbocharger Break-In IMPORTANT: A new or repaired turbocharger DOES NOT have an adequate oil supply for immediate start-up of engine. Perform the steps below to prevent damage to turbocharger bearings. 1. Remove ECU power fuse so engine does not start. IMPORTANT: DO NOT crank engine longer than 30 seconds at a time to avoid damage to starter motor. 2. Crank engine over with starter motor until oil pressure gauge needle registers within the “GREEN” zone of pressure gauge. 3. Install ECU power fuse. Start and run engine at low idle while checking oil inlet and all piping connections for leaks.

CTM100 (06APR04) 02-080-17 P OWER T ECH 10.5 L & 12.5 L Diesel Engines RG,RG34710,248 –19–30SEP97–1/1 040604 PN=317 Air Intake and Exhaust System Connect turbocharger oil inlet line (D) and tighten both ends to specifications. Specification Turbocharger Oil Inlet Line (Both Ends)—Torque................................................................ 35 N•m (26 lb-ft) IMPORTANT: Since the greatest suction force occurs between air cleaner and turbocharger, ensure that hose connections are tight to prevent entry of dirt into system. 6. Connect air inlet hose-to-turbocharger compressor housing. 7.

Install air intake and exhaust piping onto turbocharger compressor and turbine ends as detailed in machine technical manual. RG,RG34710,247 –19–13AUG99–2/2 02 080 17