Delphi — Remove, Inspect, and Install Intake Manifold

CTM100 (06APR04) 02-080-21 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=321 Air Intake and Exhaust System Remove, Inspect, and Install Intake Manifold NOTE: Intake manifolds differ between engine applications. Manifold shown has inlet on end of manifold. Some manifolds have center inlets. –UN–05DEC97 Remove Intake Manifold 1. If required, remove final fuel filter (A). Disconnect fuel lines (B) from filter mounting base. RG8184B 2. Refer to your machine technical manual to disconnect intake piping, sensors, and starting aid that is Intake Manifold Assembly (6105HRW and 6125HRW Engines with connected to intake manifold. Dual Rail Fuel Systems Shown) A—Final Fuel Filter NOTE:

If required, note location of primary fuel filter/water B—Fuel Lines separator bracket (C) for assembly in same C—Primary Fuel Filter/Water Separator Bracket location as removed. 3. Remove top cap screw on each end of intake manifold and install guide pins. 4. Remove remaining cap screws and remove intake manifold with gasket. Discard gasket. Inspect Intake Manifold 1. Check intake manifold for damage or cracks. 2. Thoroughly inspect interior of manifold for dust or debris. 3. Clean all gasket material from intake manifold and cylinder head mounting surfaces. Install Intake Manifold 1. Install guide pins at each end of top intake manifold cap screw locations. 2.

Install a new gasket onto guide pins. 3. Install intake manifold onto guide pins. If required, install primary fuel filter/water separator in same location as removed. Continued on next page RG,RG34710,250 –19–03NOV00–1/2 02 080 21