Delphi — General Engine Operation

Base Engine Operation The engine oil filter (P) mounts to a combination oil filter housing and pressure regulator housing. These items then bolt together with the oil cooler housing (A) located on the right side of the block. strength and durability for the higher power output of the 6125 engine. The skirt of the piston is aluminum to reduce the overall weight of the piston. A gear train on the front of the engine consists of four gears connecting the crankshaft with the camshaft. The crankshaft gear drives the oil pump gear (B), which drives the engine coolant pump gear and the idler gear (C). The idler gear then drives the camshaft gear (D).

A backlash adjustment is required during assembly. No timing marks are used on the gears. The 6105 and 6125 pistons have a centered, symmetrical bowl to provide efficient combustion, which allows the engine to produce high power with low exhaust emissions. 03 120 The hardened piston pins are highly polished, fully floating, and held in place by snap rings. 2 Connecting rods (J) are made of forged steel and have replaceable bushing and bearing inserts. They are weight controlled (by machining) on both ends to minimize engine vibration. A timing pin procedure is used to increase the accuracy of the gear train adjustment.

To locate top dead center of the crankshaft for number one and number six cylinders, a timing pin is installed through a timing hole on the right side of the block. The pin will engage a slot cut into a counterweight of the crankshaft. WEAR-GARD bearings are used on the connecting rod. These bearing have a lube pocket to provide an extra volume of oil to lubricate and cool the crankshaft. The crankshaft (E) is a heat treated, dynamically balanced steel forging which rotates in replaceable main bearings. Thrust washers are added to the number five main bearing to reduce crankshaft defection and to limit end play during high load operation.

A crankshaft damper (Q) is installed on the front of the crankshaft to reduce shock loads during engine operation. The flywheel (R) also dampens load changes. The engine is equipped with an oil spray jet (K) for each cylinder, installed through the right side of the cylinder block. The spray jets precisely spray a stream of oil directly from the main oil galley onto the bottom of the pistons. This provides piston cooling and lubrication for the piston pin and the connecting rod bushing. The cylinder head is an air-flow-through design. The exhaust manifold is located on the left side of the head; the intake manifold on the right.

Intake and exhaust passages have been optimized for the most efficient air flow, raising the volumetric efficiency of the engine. Intake ports are short to reduce intake air heating. Exhaust ports are short to reduce heat rejection to the head. The head contains the camshaft (L), 4 valves per cylinder (M), the rocker arm assemblies, and the electronic unit injectors (N). The head has replaceable powdered metal or cast iron valve guides and valve seats. Cylinder liners (F) are wet sleeve, flanged, and centrifugally cast using a strong durable alloy. O-rings (G) are used to seal the connection between the cylinder block and liners. Liners incorporate top liner cooling passages.

6105 engines use an aluminum piston with a 3 ring configuration (I). The top two rings are compression rings and the lower ring is an oil control ring. Double Ni-Resist ring carriers are cast integrally in the piston to greatly improve the life of the ring grooves. 6125 engines use an articulated or two piece piston (H). The crown of the piston is steel. This adds CTM100 (06APR04) 03-120-2 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,1518 –19–09SEP02–2/3 040604 PN=334