Delphi — General Engine Operation

Base Engine Operation The camshaft turns in the head on four replaceable bushings. The camshaft directly actuates the rocker arms for the valves and the rocker arm for the electronic unit injectors. Rocker arms rotate on a two-piece rocker arm shaft (O). The rocker arms for cylinders 1, 2, and 3 rotate on one half of the two piece shaft; the rocker arms for cylinders 4, 5, and 6 rotate on the other half. Rollers built in to each rocker arm ride on the camshaft lobes. The valve rocker arms push on a short push rod. The push rod actuates a bridge that will then operate two valves. Four valves per cylinder increases engine air flow compared to using one large intake and one large exhaust valve.

The intake valves for each cylinder are located towards the front of engine. The exhaust valves are located towards the rear. The intake valves and exhaust valves are the same size. The difference between the two can be determined by the fact that the intake valves are all magnetic. The head of the exhaust valves are a stellite alloy and are not magnetic. The electronic unit injector rocker arm directly actuates an injector for each cylinder. The injectors are located so that they spray fuel directly into the center of the cylinder. The injectors deliver fuel at a much higher pressure (approximately 23,200 psi) than what is achievable with an in-line or rotary injection pump.

03 120 3 RG,RG34710,1518 –19–09SEP02–3/3 CTM100 (06APR04) 03-120-3 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=335