Delphi — Check Camshaft-to-Crankshaft Timing

CTM100 (06APR04) 04-150-23 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=371 Observable Diagnostics and Tests Check Camshaft-to-Crankshaft Timing Check Camshaft-to-Crankshaft Timing 1. Remove rocker arm cover. See (REMOVE AND INSTALL ROCKER ARM COVER in Group 020.) 2. Remove plug from cylinder block and install JDG820 Flywheel Turning Tool (B). IMPORTANT: JDG971 Timing Pin MUST BE installed into camshaft timing slot (A) first before attempting to install second timing pin into crankshaft timing slot (C). 3. Rotate engine flywheel in running direction (Counter-clockwise as viewed from rear) until JDG971 –UN–05DEC97 Timing Pin (A) engages single timing slot (D) in camshaft.

The proper timing slot can be found by viewing camshaft timing lobe through camshaft timing pin bore while rotating engine. The double timing slot RG8228A (E) will be at approximately 11 o’clock (viewed from rear of engine) when pin is installed in slot (D). This JDG971 Timing Pin in Camshaft ensures that engine is locked at TDC of No. 1 cylinder’s compression stoke. Intake and exhaust rocker arms on No. 1 cylinder should be loose. 4. Remove threaded plug from crankshaft timing hole below oil cooler and filter housing assembly. –UN–05DEC97 IMPORTANT:

DO NOT insert timing pin full depth into cylinder block crankshaft timing hole when rotating engine flywheel until double slot on camshaft timing lobe is RG8227D at approximately 11 o’clock (viewed from rear of engine) to avoid crankshaft counterweight bending timing pin. JDG971 Timing Pin in Crankshaft 5. Slightly move engine flywheel back and forth with turning tool until a second JDG971 Timing Pin (C) can be installed in slot in crankshaft. This ensures that camshaft and crankshaft are in sync (properly timed).

A—Timing Pin B—Flywheel Turning Tool –UN–30OCT00 C—Timing Pin D—Single Timing Slot E—Double Timing Slot RG11165 Camshaft Timing Slot Continued on next page DPSG,RG40854,357 –19–06NOV00–1/2 04 150 23