Delphi — Check Crankshaft Position Sensor Depth

Observable Diagnostics and Tests If timing pin does not enter crankshaft timing slot, crankshaft MUST BE timed to camshaft. See CHECK AND ADJUST CAMSHAFT-TO-CRANKSHAFT TIMING in Section 02, Group 050. DPSG,RG40854,357 –19–06NOV00–2/2 Check Crankshaft Position Sensor Depth NOTE: Crankshaft vibration damper and front seal shown removed The ECU monitors the position of the crankshaft and camshaft to determine piston position and the optimum time to start and stop injecting fuel. This crank sensor sends the crank position to the ECU. RG10290 –UN–24AUG99 04 150 1. Disconnect crankshaft position sensor wiring connector. 24 2. Remove sensor (B) from timing gear cover. Crankshaft Position Sensor 3.

Install JDG1334 Tool (C) in sensor bore in timing gear cover until the tool is hand tight within the timing gear cover. 4. Push in on pin (C) until it contacts crankshaft timing wheel (H). 5. Check position of pin end in relation to end of tool as shown in (D, E, F) If pin’s lower shoulder extends above end of tool (D), add one R60756 shim to sensor. If pin’s lower shoulder is within range of marks (E), no shim is required on sensor. If pin is below end of tool (F), call DTAC for assistance.

RG10380 –UN–19OCT99 Using JDG1334 Depth Checking Tool A—Machined Mounting Surface (Spotface) B—Crankshaft Position Sensor C—Pin (In JDG1334 Depth Tool) D—Sensor Depth Low (Shim Required) E—Sensor Depth Correct (No Shim Required) F—Sensor Depth too High (Requires Investigation) G—JDG1334 Depth Checking Tool H—Crankshaft Timing Wheel 6. Grease O-ring with JDT405 High Temperature Grease 7. Install sensor in timing gear cover and tighten to specification. Specification Crankshaft Position Sensor— Torque 14 (10 lb-ft) .............................................................................

CTM100 (06APR04) 04-150-24 P OWER T ECH 10.5 L & 12.5 L Diesel Engines DPSG,RG40854,466 –19–07NOV00–1/1 040604 PN=372