Delphi — Diagnosing Head Gasket Joint Failures

Cylinder Head and Valves 2. Obtain coolant and oil samples for further analysis. 3. Start and warm up engine if it can be safely operated. Examine all potential leakage areas again as outlined previously. Using appropriate test and measurement equipment, check for the following: 02 020 18 White smoke, excessive raw fuel, or moisture in exhaust system. Rough, irregular exhaust sound, or misfiring. Air bubbles, gas entrainment in radiator or overflow tank. Loss of coolant from overflow. Excessive cooling system pressure. Coolant overheating. Low coolant flow. Loss of cab heating (air lock). 4. Shut engine down.

Recheck crankcase, radiator, and overflow tank for any significant differences in fluid levels, viscosity, or appearance. 5. Compare your observations from above steps with the appropriate diagnostic procedures in Section 04, Group 150. If diagnostic evaluations and observations provide conclusive evidence of combustion gas, coolant, or oil leakage from head gasket joint, the cylinder head must be removed for inspection and repair of gasket joint components. RG,RG34710,69 –19–01NOV00–2/2 CTM100 (06APR04) 02-020-18 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=90