Delphi — Head Gasket Inspection and Repair Sequence

Cylinder Head and Valves CTM100 (06APR04) 02-020-19 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=91 Head Gasket Inspection and Repair Sequence –UN–19MAY98 RG8429 Cylinder Head Gasket Inspection A—Combustion Seals B—Gasket Body C—Front of Engine (Flanges) The following inspection procedures are recommended Examine gasket body (B) for the following: whenever a head gasket joint failure occurs or when joint disassembly takes place. • Combustion gas erosion paths or soot deposits originating at combustion seals. 1. Review historical data relating to machine • Extreme discoloration/hardening/embrittlement in operation, maintenance and repair, along with localized areas.

diagnostic observations. Note all areas requiring • Oil or coolant paths from port areas. further inspection and analysis. • Localized areas of low compression. 2. Remove rocker arm cover and check for presence 6. Before cleaning components, inspect head, block, of coolant in the oil. and liners for evidence of combustion gas and fluid leakage. Inspect cylinders and valve ports for 3. Record head cap screw torques prior to removal. unusual deposits. Upon removal, check cap screw length differences. 7. Clean cylinder block. (See INSPECT AND CLEAN 4. Remove cylinder head using appropriate lifting CYLINDER BLOCK in Group 030.) Clean cylinder devices to prevent handling damage to head head.

(See CLEAN AND INSPECT CYLINDER gasket. (See REMOVE CYLINDER HEAD in this HEAD in this group.) Clean liners. (See CLEAN group.) CYLINDER LINERS in Group 030.) 5. Observe surfaces of removed head gasket. 8. Proceed with the following dimensional checks and visual inspections: Examine combustion seals (A) for the following: • Cylinder Head (this group) • Flange severed/expanded/cracked/deformed. – Check surface flatness/finish. • Adjacent body area burned/eroded. – Inspect for surface damage. • Fire ring severed/displaced/missing. – Check cylinder head thickness, if resurfacing. • Flange sealing pattern eccentric/contains voids.

• Cylinder Block and Liners (assembled and • Discoloration of flange and adjacent body areas. clamped) (Group 030) • Flange surfaces rough/abraided/channelled. Continued on next page RG,RG34710,70 –19–30SEP97–1/2 02 020 19