Delphi — Check Valve Height in Relation to Head Surface (Valve Recess)

Cylinder Head and Valves Check Valve Height in Relation to Head Surface (Valve Recess) 1. Thoroughly clean all gasket material from cylinder head combustion face. 2. Measure and record valve recess using JDG451 (English) or KJD10123 (Metric) Height Gauge (A) along with D17526CI (English, in.) or D17527CI Dial Indicator (Metric) (B). Measurements must be made a maximum of 3.0 mm (0.12 in.) in from edge of valve head. RG8330A –UN–09DEC97 Specification Intake and Exhaust Valves— Recess 1.85—2.35 mm (0.073—0.093 in.) .................................................

Measure Valve Recess A—Height Gauge B—Dial Indicator Install new valves, inserts, or grind existing valves and inserts (as necessary) to obtain specified valve recess. CTM100 (06APR04) 02-020-23 P OWER T ECH 10.5 L & 12.5 L Diesel Engines RG,RG34710,74 –19–03NOV99–1/1 040604 PN=95 Assemble Rocker Arms and Shaft Assembly 1. Make sure that rocker arm shaft end plugs are firmly seated in each shaft end bore. 2. Assemble parts on rocker arm shaft in reverse sequence as removed. –UN–21MAY98 3. Install cap screws (B) and (C) in holes at each end of rocker arm shaft to keep rocker arms from sliding off shaft during installation. RG8460 4.

Install JDG970A Rocker Arm Lifting Fixture (A) onto Rocker Arm and Shaft Assembly rocker arm and shaft assembly. A—JDG970A Rocker Arm Assembly Lifting Fixture B—Cap Screw C—Cap Screw –UN–06DEC97 RG8304 Lifting Rocker Arm Assembly RG,RG34710,73 –19–13AUG99–1/1 02 020 23