TM2361 (24JUN08) 9015-15-5 450DLC Excavator Operation and Tests 062608 PN=449 Sub-System Diagnostics Output voltage from alternator (G3) terminal L is routed switch is turned to the OFF or ACC position to the monitor controller (A4) pin C7, turning off the momentarily. alternator indicator light. If voltage at alternator terminal L drops below operating voltage, alternator Load Dump Circuit—The load dump circuit consists voltage indicator will illuminate. Output voltage from of load dump relay (K1) and load dump relay diode terminal L is also supplied to the information controller (V3). (ICF).
When the alternator (G3) is generating electricity, Alternator output voltage from terminal L is also routed output voltage is sent to monitor controller (A4) pin C7. to the starter protection relay (K18) terminal R. When This causes monitor to ground pin A12, energizing alternator output voltage increases up to 21—22 volts, load dump relay. With load dump relay energized, the starter protection relay disconnects terminal B from battery power is applied through terminals 3 and 5 to terminal C, removing power from starter motor (M1). battery relay (K19).
Monitor controller terminal A12 The starter motor will then stop cranking engine or retains a ground path for load dump relay until prevent it from engaging if the engine is running and alternator stops producing output voltage. This keeps the alternator is producing power. the battery relay energized, providing a path to the batteries (G1 and G2) for any power produced by the When alternator output voltage is present at monitor alternator as the engine slows to a stop. Then the controller pin C7, load dump relay (K1) is energized by ground path is removed from load dump relay, and a ground from the monitor controller pin A12. With load battery relay is de-energized.
dump relay energized, battery power is supplied to battery relay (K19) pin S. This keeps the battery relay Load dump relay diode (V3) isolates battery power at energized to ensure that output voltage from the terminal 5 of load dump relay (K1) from key switch ON alternator is routed to the batteries as long as the power circuits. alternator is producing output voltage, even if the key LD30992,000020D –19–27APR06–3/3 9015 15 5