John Deere 450DLC — Alternator Test

TM2361 (24JUN08) 9015-20-99 450DLC Excavator Operation and Tests 062608 PN=589 References Alternator Test 4 5 6 2 + 3 7 1 8 9 - –UN–31MAR06 TX1005683 TX1005683 Alternator Circuit 1—Battery 4—B+ Terminal 6—L Terminal 8—Rectifier Bridge 2—Battery Relay 5—R Terminal 7—Regulator 9—Field Coil 3—Stator Coil 1. 24 V System — With engine running at slow idle, 4. With jumper wire in place between B+ & R, check check DC voltage between terminal R (5) and voltage on B+ terminal. ground. Voltage should be 27.5 VDC or greater1. If alternator voltage increases, check for problem in 2. With engine running at slow idle, check DC voltage excitation circuit. between terminal B+ (4) and ground.

Voltage should be 27.5 VDC or greater1. 5. Disconnect L & R connector. 3. If voltage from previous steps is below 27.5 VDC1, 6. Check voltage on pin L (6) of the alternator side. check excitation by disconnecting the L (6) and R Voltage should be 27.5 VDC or greater. (5) connector and place a jumper wire between the B+ (4) terminal and the alternator side of the R (5) 7. Repeat above steps with lights on to load the terminal with the engine running. alternator. 1Note: For 24 V systems with maintenance free batteries, R and B+ voltage should be 28.2 VDC or greater. Continued on next page LD30992,000022F –19–28APR06–1/2 9015 20 99