John Deere 450DLC — Component Checks

TM2361 (24JUN08) 9015-20-102 450DLC Excavator Operation and Tests 062608 PN=592 References Starter Protection Relay YES: Continue checkout. Check NO: Check battery relay. See Battery Relay Check. (Group 9015-20.) Check wiring to relay. See Machine Harness (W2) Wiring Diagram. (Group 9015-10.) TX1005690A –UN–30MAR06 Starter Protection Relay 1—C Terminal 2—B Terminal 3—R Terminal 4—E Terminal 5—S Terminal 6—3 Wire Connector 7—Starter Protection Relay 9015 TX1005798A –UN–04APR06 Turn key switch ON. 20 Measure voltage on pin B (2). ,102 Is battery voltage present? NOTE: Disconnecting wire connector (6) will keep the engine from starting. YES: Continue checkout.

Disconnect starter protection relay from harness at connector (6). NO: Check starter relay. See Relay Test. (Group Turn and hold key switch in START position. 9015-20.) Measure voltage on pin S (5). Check wiring to starter protection relay. See Is battery voltage present with the key switch held in the START position? Machine Harness (W2) Wiring Diagram. (Group 9015-10.) See Cab Harness (W1) Wiring Diagram. (Group 9015-10.) Disconnect wire connector (6) from relay. YES: Check for short to power. See Machine Turn key switch to the ON position. Harness (W2) Wiring Diagram. (Group Measure voltage at pin R (3). 9015-10.) Is battery voltage present? NO: Continue checkout.

– – –1/2 References Starter Protection Relay Check TX1005690A –UN–30MAR06 Starter Protection Relay 1—C Terminal 2—B Terminal 3—R Terminal 4—E Terminal 5—S Terminal 6—3 Wire Connector 7—Starter Protection Relay Turn key switch ON. TX1005798A –UN–04APR06 Measure voltage on pin B (2). Is battery voltage present? YES: Continue checkout. NO: Check battery relay. See Battery Relay Check. (Group 9015-20.) Check wiring to relay. See Machine Harness (W2) Wiring Diagram. (Group 9015-10.) 9015 20 ,102 NOTE: Disconnecting wire connector (6) will keep the engine from starting. Disconnect starter protection relay from harness at connector (6). Turn and hold key switch in START position.

Measure voltage on pin S (5). Is battery voltage present with the key switch held in the START position? YES: Continue checkout. NO: Check starter relay. See Relay Test. (Group 9015-20.) Check wiring to starter protection relay. See Machine Harness (W2) Wiring Diagram. (Group 9015-10.) See Cab Harness (W1) Wiring Diagram. (Group 9015-10.) Disconnect wire connector (6) from relay. Turn key switch to the ON position. Measure voltage at pin R (3). Is battery voltage present? YES: Check for short to power. See Machine Harness (W2) Wiring Diagram. (Group 9015-10.) NO: Continue checkout. – – –1/2