John Deere 450DLC — Component Checks

References TM2361 (24JUN08) 9015-20-103 450DLC Excavator Operation and Tests 062608 PN=593 Reconnect wire connector (6). Start engine Disconnect wire connector (6) from relay with engine running. Measure voltage at pin R (3). Is voltage approximately 24 volts or higher? YES: Continue checkout. NO: Check alternator output. See Alternator Test. (Group 9015-20.) Check wiring between relay and alternator. See Machine Harness (W2) Wiring Diagram. (Group 9015-10.) See Engine Interface Harness (W5) Wiring Harness. (Group 9015-10.) Turn key switch to the OFF position. Measure for continuity between pin E (4) connector side and machine ground. Is there continuity? YES:

Starter protection relay malfunction, replace relay. NO: Check wiring. See Machine Harness (W2) Wiring Diagram. (Group 9015-10.) –19– –2/2 9015 20 ,103 Glow Plug Relay Check 1—Pin 1 2—Pin 2 3—Pin 3 4—Pin 4 Remove glow plug relay from machine. See Machine Harness (W2) Component Location. (Group 9015-10.) Measure for continuity between pins 1 and 2. TX1005783A –UN–04APR06 Is there continuity? Glow Plug Relay YES: Glow plug relay malfunction, replace relay. NO: Continue checkout. Measure resistance between pins 3 and 4. Is there approximately 98 ohms? YES: Continue checkout. NO: Glow plug relay malfunction, replace relay. Connect 24 volts to pin 1 and ground pin 2. LISTEN: Does the relay click?

YES: Relay is good. NO: Glow plug relay malfunction, replace relay. – – –1/1