“Popping” Of Track Diagnostic Procedure –1/1 Cracked Track Link Diagnostic Procedure –1/1 TM2361 (24JUN08) 9020-15-4 450DLC Excavator Operation and Tests 062608 PN=632 Diagnostic Information 3 Machine Operating Condition Check Inspect worksite and interview machine operator. • Check if machine is operated on rough and rocky terrain. • Check if operator ever uses the slow speed (turtle) mode. Does operator understand how machine damage can be reduced? YES: Diagnostic procedure complete. NO: Instruct operator on the correct operating procedures of traveling in slow speed (turtle) mode on rough and rocky terrain. See Operator’s Daily Machine Check Before Starting.
(Operator’s Manual.) – – –1/1 1 Machine Operating Condition Check Inspect worksite and interview machine operator. • Check if machine is operated at high speed in reverse. • Check if operator ever uses the slow speed (turtle) mode. Does operator understand that traveling in reverse should be minimized? YES: Go to Sprocket Check. NO: Instruct operator that high travel loads in reverse can cause the recoil spring to retract allowing sprocket to slip in chain and make this noise. – – –1/1 9020 15 4 2 Sprocket Check Check sprocket for packed material and rocks. Is sprocket free of excess material? YES: Diagnostic procedure complete. NO: Clean material from sprocket. – – –1/1