Function Does Not Stop When Control Lever Released Diagnostic Procedure –1/1 Some Functions Cannot Be Operated, All Others Are Normal Diagnostic Procedure –1/1 TM2361 (24JUN08) 9025-15-13 450DLC Excavator Operation and Tests 062608 PN=763 Diagnostic Information 6 Actuating Pilot Pressure Check Key on, use monitor service menu to display Swing / Attachment Control Pilot Pressure. See Monitor Service Menu Operation. (Group 9015-16.) NOTE: Spool actuating pressure can be checked for each function by installing a tee and gauge in pilot line and then actuating that function. Perform Control Valve Spool Actuating Pilot Pressure Test.
(Group 9025-25.) Run engine at fast idle and operate problem function. Observe pressure when function held over relief. Is pilot pressure above 3.70 MPa? YES: Diagnostic procedure complete. NO: If pressure is low, adjust or replace valve. Perform Pilot Pressure Regulating Valve Test and Adjustment. (Group 9025-25.) – – –1/1 1 Pilot Shutoff Lever Check Run engine at slow idle with pilot shutoff lever to down position. Activate problem function, then move lever to raised position. Does function stops when pilot shutoff lever is raised? YES: Go to Pilot Control Valve Check. NO: Go to Control Valve Spool Stuck Check.
– – –1/1 2 Control Valve Spool Stuck Check See Control Valve Disassemble and Assemble. (Group 3360.) Inspect control valve spool. Does control valve spool move freely? YES: Diagnostic procedure complete. NO: Repair or replace control valve components as necessary. – – –1/1 9025 15 13 3 Pilot Control Valve Check See Control Valve Operation. (Group 9025-05.) Inspect pilot control valve for sticking spool. Does pilot control valve spool move freely? YES: Diagnostic procedure complete. NO: Inspect, repair or replace pilot control valve. See Pilot Control Valve Disassemble and Assemble. (Group 3360.) – – –1/1