John Deere 450DLC — HP (High Power) Function Does Not Operate, P (Standard) Mode Is Normal Diagnostic Procedure

TM2361 (24JUN08) 9025-15-29 450DLC Excavator Operation and Tests 062608 PN=779 Diagnostic Information 1 DTC Check See Reading Diagnostic Trouble Codes With Monitor Display. (Group 9015-20.) See Reading Diagnostic Trouble Codes With Service ADVISORDiagnostic Application Are any of the following DTC displayed? • 11200.03 See Pump 1 Delivery Pressure Sensor Circuit Voltage High. (Group 9001-10.) • 11200.04 See Pump 1 Delivery Pressure Sensor Circuit Voltage Low. (Group 9001-10.) • 11301.03 See Swing Pilot Pressure Sensor Circuit Voltage High. (Group 9001-10.) • 11301.04 See Swing Pilot Pressure Sensor Circuit Voltage Low.

(Group 9001-10.) • 11400.03 See Pump 2 (5-Spool) Control Solenoid Valve Feedback Current High. (Group 9001-10.) • 11400.04 See Pump 2 (5-Spool) Control Solenoid Valve Feedback Current Low. (Group 9001-10.) YES: Diagnose and repair as required to clear displayed DTC. Diagnostic procedure complete. NO: Go to Boom Mode Selector Switch Check. (Group 9025-15.) – – –1/1 2 Boom Mode Selector Switch Check Key on, use monitor service menu to display Pump 1 Delivery Pressure. See Monitor Service Menu Operation. (Group 9015-16.) Put boom mode switch in off position. Run engine at fast idle and lower boom to raise one track off ground. Record maximum pressure. Does delivery pressure exceed 31.0 MPa?

YES: Diagnostic procedure complete. NO: Adjust circuit reliefs. See Circuit Relief Valve Test and Adjustment. (Group 9025-25.) – – –1/1 9025 15 29 HP (High Power) Function Does Not Operate, P (Standard) Mode Is Normal Diagnostic Procedure – – –1/1 1 Power Mode Switch Check Key on, use monitor service menu to display Power Mode and Actual Engine Speed. See Monitor Service Menu Operation. (Group 9015-16.) Engine off, turn power mode switch to E, P and HP positions and observe monitor. Does monitor display correspond with each switch position? YES: Go to HP Engine Speed Check. NO: Check wiring harness. See Cab Harness (W1) Wiring Diagram. (Group 9015-10.) – – –1/1