Machine Mistracks At All Speeds In Both Directions Diagnostic Procedure –1/1 TM2361 (24JUN08) 9025-15-52 450DLC Excavator Operation and Tests 062608 PN=802 Diagnostic Information 6 Travel Motor And Gearbox Check See Travel Motor and Park Brake Disassemble and Assemble. (Group 0260.) See Travel Gearbox Disassemble and Assemble. (Group 0250.) Inspect travel motor and gearbox for mechanical failure. Is travel motor and gearbox OK? YES: Diagnostic procedure complete. NO: Repair or replace travel motor or gearbox. – – –1/1 1 Track Sag Check Check track sag. See Check and Adjust Track Sag. (Operator’s Manual.) Is track sag within specification? YES: Go to Actuating Pilot Pressure Check. NO:
Adjust track sag. – – –1/1 2 Actuating Pilot Pressure Check Key on, use monitor service menu to display Travel Pilot Pressure. See Monitor Service Menu Operation. (Group 9015-16.) NOTE: Spool actuating pressure can be checked for each function by installing a tee and gauge in pilot line and then actuating that function. Perform Control Valve Spool Actuating Pilot Pressure Test. (Group 9025-25.) Run engine at fast idle and raise problem track off ground. Observe pressure when operating lever full travel. Is pilot pressure above 3.70 MPa? YES: Go to Travel Motor Crossover Relief Valve Check. NO: If pressure is low, adjust or replace valve.
Perform Pilot Pressure Regulating Valve Test and Adjustment. (Group 9025-25.) – – –1/1 9025 15 52 3 Travel Motor Crossover Relief Valve Check Perform Travel Motor Crossover Relief Valve Test and Adjustment. (Group 9025-25.) Test travel motor crossover relief valve. Is travel motor crossover relief valve OK? YES: Go to Servo Piston Shuttle Valve Check. NO: Repair or replace travel motor crossover relief valve. See Travel Motor Cover Disassemble and Assemble. (0260.) – – –1/1