TM2361 (24JUN08) 9025-15-55 450DLC Excavator Operation and Tests 062608 PN=805 Diagnostic Information 5 Rotary Manifold Leakage Check Perform Rotary Manifold Air Test. (Group 0260.) Inspect rotary manifold for leakage. Is rotary manifold OK? YES: Go to Hydraulic Pump Check. NO: Repair or replace rotary manifold. See Rotary Manifold Disassemble and Assemble. (Group 0260.) – – –1/1 6 Hydraulic Pump Check Perform Cycle Times Check. (Group 9005-10.) Slow travel cycle times may indicate worn pump. If travel cycle times do not meet specification, check pump flow. Perform Pump Flow Test. (Group 9025-25.) Do travel cycle times and pump flow meet specification? YES: Go to HP Engine Speed Check. NO:
Repair or replace pump. See Pump Remove and Install. (Group 3360.) – – –1/1 7 HP Engine Speed Check Key on, use monitor service menu to display Actual Engine Speed and Power Mode. See Monitor Service Menu Operation. (Group 9015-16.) Put power mode switch on P and work mode on digging. Run engine at fast idle and take arm-in function over relief. Record engine speed. Turn power mode switch to HP position. Does engine speed increase approximately 100 rpm when switch is moved to HP? YES: Go to Power Boost Pressure Check. NO: Select correct engine speed and power mode setting. See Engine Speed Control System Operation.
(Group 9010-05.) – – –1/1 9025 15 55 8 Power Boost Pressure Check Key on, use monitor service menu to display Pump 1 or Pump 2 Delivery Pressure. See Monitor Service Menu Operation. (Group 9015-16.) Put power mode switch on HP and work mode on digging. Run engine at fast idle and take arm-in function over relief. Record pressure. Push power dig switch on control lever and observe monitor. Does pump 1 and 2 delivery pressure increase approximately 2.5 MPa when power dig switch held on? YES: Diagnostic procedure complete. NO: Replace or adjust main relief valve. See Main Relief and Power Digging Valve Test and Adjustment. (Group 9025-25.) – – –1/1