John Deere 450DLC — Hydraulic Oil Warm-Up Procedure

TM2361 (24JUN08) 9025-25-6 450DLC Excavator Operation and Tests 062608 PN=866 Tests 4. Run machine at specification. Specification Engine—Speed..................................................1/2 Speed if below -18°C 1/2 Speed if below 0°F Fast Idle if above -18°C Fast Idle if above 0°F Power Mode Switch—Position...................... E Mode (Economy) if below -18°C E Mode (Economy) if below 0°F HP Mode (High Power) if above -18°C HP Mode (High Power) if above 0°F Work Mode Switch—Position...................................................... Dig Mode Auto Idle Switch—Position..................................................................

OFF Travel Speed Switch—Position.............................................. Slow (Turtle) 5. Slowly turn upperstructure so boom is to the side. CAUTION: Avoid possible serious injury from machine sliding backwards. Keep angle between boom and arm at 90—110°. 6. Keeping the angle between boom and arm at 90— 110°, lower boom to raise track off the ground. 7. Operate travel function for approximately 5 minutes. 8. When oil temperature is above -18°C (0°F), increase engine speed to fast idle and turn power mode switch to HP (high power). IMPORTANT: Holding a function over relief for more 9025 25 6 than 10 seconds can cause damage due to hot spots in the control valve. 9.

Operate the travel function (side with track off the ground). Also operate the bucket curl function over relief for 10 seconds and then stop for 5 seconds. Repeat the cycle until oil is heated to specifications. 10. Stop periodically and operate all hydraulic functions to distribute the heated oil. 11. Continue procedure until oil temperature is within specifications. Continued on next page TX04577,00000E7 –19–05JUN06–3/4