John Deere 450DLC — Travel Speed Solenoid Valve (port SI) Test and Adjustment

TM2361 (24JUN08) 9025-25-23 450DLC Excavator Operation and Tests 062608 PN=883 Tests 9. Adjust the solenoid valve (H) as needed. IMPORTANT: Turning adjusting screw out too far may cause oil leakage because the O-ring has come off its seat. –UN–20JUN96 a. Loosen nut (J). b. Turn adjusting screw (I) in to increase pressure setting; turn adjusting screw out to decrease T101709 pressure setting. The length from end of adjusting screw to nut must not exceed the specified length. Specification H—Solenoid Valve Solenoid Valve Adjusting Screw— I—Adjusting Screw Pressure Change.....................................

0.069 MPa approximate per 1/4 J—Nut turn 69 kPa approximate per 1/4 turn 0.69 bar approximate per 1/4 turn 10 psi approximate per 1/4 turn End of Adjusting Screw-to-Nut— Length............................................................................... 2 mm maximum 0.079 in. maximum c. Hold adjusting screw and tighten nut. Specification Solenoid Valve Adjusting Screw-to-Housing Nut—Torque.................................................... 3.0 N•m 27 lb-in. 10. Check the pressure setting again. LD30992,00002B2 –19–05JUN06–5/5 9025 25 23