TM2361 (24JUN08) 9025-25-51 450DLC Excavator Operation and Tests 062608 PN=911 Tests Pump Flow Rate (Displacement) Test and Adjustment SPECIFICATIONS Pump 1 Flow Rate 38 L/min approximate per 1/4 turn (Displacement) Flow Rate 10 gpm approximate per 1/4 turn Change Pump 2 Flow Rate 36.9 L/min approximate per 1/4 (Displacement) Flow Rate turn Change 9.7 gpm approximate per 1/4 turn Pump flow rate (displacement) is controlled by a pilot oil signal from the solenoid valve to the pilot piston and load spool in proportion to the current signal to the solenoid. See System Functional Schematic for pump 1 (4-Spool) –UN–08MAY01 control solenoid and pump 2 (5-Spool) control solenoid.
(Group 9015-10.) Pump flow rate control adjusting screw (1) is used to T141997 adjust the response of pilot piston and load spool in proportion to the pilot oil signal by changing the spring Pump Flow Rate Control Adjusting Screw force. See Pump 1 and 2 Regulator Operation for more 1—Pump Flow Rate Control Adjusting Screw information. 1. Check the maximum and minimum flow rates. See Pump Flow Test for instruction to connect flow meter. 2. Turn adjusting screw in to decrease flow rate; turn adjusting screw out to increase flow rate. Specification Pump 1 Flow Rate (Displacement)—Flow Rate Change................................................
38 L/min approximate per 1/4 turn 10 gpm approximate per 1/4 turn Pump 2 Flow Rate (Displacement)—Flow Rate Change..................................................... 36.9 L/min approximate per 1/4 turn 9.7 gpm approximate per 1/4 turn NOTE: The flow rate change for pump 1 is greater because pump 1 turns at 1.03 times engine speed. LD30992,0000284 –19–24APR06–1/1 9025 25 51 SPECIFICATIONS Pump 1 Flow Rate (Displacement) Flow Rate Change 38 L/min approximate per 1/4 turn 10 gpm approximate per 1/4 turn Pump 2 Flow Rate (Displacement) Flow Rate Change 36.9 L/min approximate per 1/4 turn 9.7 gpm approximate per 1/4 turn