John Deere 450DLC — System Relief Valve Test and Adjustment

TM2361 (24JUN08) 9025-25-76 450DLC Excavator Operation and Tests 062608 PN=936 Tests NOTE: Hose connection for standard fan drive control valve and motor is shown. Hose connection for the fan drive reversing control valve and motor is similar. 8. Disconnect the hoses (10) for fan drive motor (36) at the adapter fittings (8) in fan drive control valve (37). Install X12FNL-S (Parker No. 12FNL-S) (-12 F ORFS) caps on fittings. 9. Disconnect wiring harness to the fan pump control solenoid so fan drive pump goes to maximum 36 displacement. 10. Run machine at specification. 10 Specification 8 Engine—Speed............................................................................

Fast Idle Work Mode Switch—Position...................................................... Dig Mode Power Mode Switch—Position.............................. HP (High Power) Mode –UN–28APR06 10 Auto Idle Switch—Position.................................................................... Off 8 37 11. Record the pressure reading. 38 TX1007109 Specification Fan Drive System Relief Valve— Pressure................................................... Information not available at the Fan Drive Control Valve-to-Motor Hoses time of release. 8—Adapter Fitting (2 used) 12.

Turn the adjusting screw for fan drive system relief 10—Hoses (2 used) valve (38) in to increase pressure setting; turn 36—Fan Drive Motor adjusting screw out to decrease pressure setting. 37—Fan Drive Control Valve 38—Fan Drive System Relief Valve 9025 25 76 LD30992,0000285 –19–16MAY08–3/3