Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION CHECK ELECTRIC WIRING WARNING NOTICE If the tires are used when the inflation pressure is less than the value given in the table above, the rim may be damaged. Always keep the tire inflation pressure within +0 to +0.03 MPa (0.3 kg/cm 2 , 4.3 PSI) of the value in the table above. CHECK WATER SEPARATOR The water separator and fuel prefilter (1) are made one and composed of (2) to (4) in the lower section. 1. It is possible to judge the amount of water or sediment through transparent cap (2). If water or sediment has accumulated, put a container under drain hose (4) to catch the drained water. 2. Loosen drain valve (3) to drain the water. 3.

If fuel starts flowing out through drain hose (4), close valve (3) immediately. 3 - 77 CHECK BACKU 1. Turn the e ngine starting switch to the ON positio 2. Place the g ear shift leve r in the R pos ition and c heck tha t the backup alarm is workin If the fuse blo ws frequently o r there are sign s of short c ircuit s in the e lectrical wiring, investigate the cause immediatel y and carry out repa irs or contact y our Komatsu d istributor. Keep the top surface of the b attery clean and check the breather h ole i n the battery cap. If it is clo gged with dirt or dust, wash the battery ca p to clean the b reather hole. Check for dam age and wro ng c apacity of the fuse and any sign wiring.

Check also for loose terminals and tighten a ny loose parts Check the wiri ng of the "battery", "starting motor"an Always check i f there is any accumulation of flammable material around the battery, and remove such flammable material. your Komatsu distributor for investigation and correction of any problems found. Please contact your Komats u distributor f or investigation and correction of any problems CHECK INFLATION PRESSURE OF TIRES Use a tire pres sure gauge to measure the tire inflatio n pressure b efor e starting operations when the tires are cool. Check for dam age or wear t o the tires an d the rims. Check for loos e wheel hub b olts.

The proper infl ation pressur e is shown be Tire size Inflation pressure [MPa (kg/cm2, PSI)] Front tire Center tire Rear tire 23.5-R25 (standard) 0.44 (4.5, 63.9) 0.44 (4.5, 63.9) 0.44 (4.5, 63.9) 750/65 R25 (30/65 R25) (if equipped) 0.34 (3.5, 49.7) 0.40 (4.1, 58.2) 0.40 (4.1, 58.2)