. OPERATION OPERATION STARTING ENGINE WARNING preheating pilot lamp goes out. Engine water temperature Preheating time above - 5 ° C (23 ° F) - 5 ° C to - 20 ° C (23 ° F to - 4 ° F) 20 to 40 sec below - 20 ° C (- 4 ° F) 40 sec REMARK When the starting switch is turned to the ON position, if the engine coolant temperature is above -5 ° C (23 ° F), though preheating of the engine is carried out. In this case, it is possible to start the engine immediately. 3 - 84 Start t he e ngine only after sitting down in the operator's seat . D o no t attempt to sta rt the engine by sh ort-circuitin g the engi ne starting circuit.
Such an act may c ause a serious bodily injury or fire Check tha t there are no persons or ob stacles in the surround ing area, the n sound the horn and s Never use starting ai d fluids as they m ay cause explosions. Exhaust g as is toxic. When starting th e engine in c onfined sp aces, be particularly careful to ensu NOTICE t accelerate the engine sharply until it is warmed up. t operate the starting motor continuously for more than 20 seconds. engine fails to start, wait for 2 minutes or so, and then try to start again. D o no t accelerate th e engine sharply u D o no t operate the s tarting motor cont inuously for more than 20 seconds.
If the engine fails to start, wait for 2 mi nutes or so, and then t ry to start When starting the en gine, do not depre ss the accelerator peda l. Even if t he accelerator pedal is dep ressed just after the engine is started, the engine speed is limited by the turbo protect fu nction. After the turbo protect time, however, the engine speed rises s harply and the turbocharger ma y be damage d. 1. Turn th e key of s tarting switch (1 ) to the ON position. g to the engine engine s The engine preh engine coolant t tarts. When t eating pilot lam emperature, an he preheating p lights up accordin d preheating of the is completed, the The pre-heating t imes are as sho