Komatsu — STARTING ENGINE

. OPERATION OPERATION OPERATION OPERATION 2. After the preheater pilot lamp goes off, turn the key of the Just after the engine starts, the injection characteristics are changed for a certain time to keep the low idle speed a little high, depending on the engine coolant temperature. The engine acceleration characteristics are also changed so that the engine will be accelerated moderately. 3 - 85 ch to the START po sition, and th e engine wil l start. REMARK When starting t he engine, the moni tor may flash while the st arting motor is turning , but if the monitor l amp goes o ut afte r the e ngine is started, there is no problem. 3.

After the en gine starts, release the key of th e starting s witch. REMARK If the engine fail s to start, return the key of the sta rting s witch to the OFF position, a nd then start the op eration again from step 1 . If the starting switch i s not returned to the OFF position, the automatic not operate. matic preheater does 4. Do not ope rate the accelerator seconds at When the e idle run for ngine is started for t he first time after t he en gine oil or engine oil filter is repl aced, continu e the low at least 20 seconds to circulate t he engine o il in the engine. REMARK Since the tur bocharger rotates at very high speed, it is seized if not lubricated well.

To prevent this, the turbo urbo protect mec temperature hanism works for a certain time just after the engine starts, depending on the engine coolant . ot starts, Engine water temperature T urbo protect time above 10°C (50°F) 0 sec -10°C to 10°C (14°F to 50°F) 0 to 5 sec below -10°C (14°F) 5 sec In Engine water temperature jection characteristics change time above 20°C (68°F) 0 sec 0°C to 20°C (32°F to 68°F) 0 to 6 sec -20°C to 0°C (-4°F to 32°F) 6 to 12 sec -30°C to -20°C (-22°F to -4°F) 12 to 15 sec