Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING at the top 4 - 54 9. When installing, tig hten until the packing surface co ntacts the seal surface of the filter head, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter cartridge is too loose, fuel will also leak from t he packing, so always tighten the c When tightening with a filter wrench, be extreme ly careful not to dent or damage the 10. Check that the drai n plug at the bottom of the wate r separator cup is tightened securel Tightening torque:

0.2 to 0.45 Nm (0.02 to 0.046 kg m, 0.1 to 0.3 lbft) 11. Start the engine, ch eck that there is no leakage of f uel from the filter seal surface or wa ter separator mounting surface, then run fo r approx. 10 minutes at low idlin LUBRICATE CAB MOUNT PIN (LEFT AND RIGHT: 1 PLACE EACH) 1. Stop the engine. 2. Using a grease pump, pump in grease through the grease fittings shown by arrows. 3. After greasing, wipe off any old grease that was pushed out. Carry out the greasing operation every day when operating in places where the grease flows out easily, such as when traveling through mud or water. 1. Stop the engine. 2. Using a grease pu fittings shown by ar 3.

After greasing, wip e off any old grease that was pu Carry out the greasing operation every day when o places where the grease flows out easily, such traveling through mud or water. Carry out the greas ing operation every day when o places where the Immediately after the e ngine is stopped, the oil and parts are at high temperature, and this will temperature to go dow n before starting the operation. If there is still pressure remaining inside the case, the oil or plug may fly out. Turn the plug slowly to release the pressure, then remove it carefully. 1. Stop the machine s o that the TOP casting mark is s at the bottom. and drain plug (P) i 2.

Remove plug (G) an d check that the oil is near the b of the plug hole. 3. If the oil level is too low, add oil through the plug ho oil overflows. 4. Repeat the procedu re in Steps 1 - 3 and check the o add oil to all the fin al drive cases (front, center, rea