. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE REPLACE FUEL TANK BREATHER ELEMENT WARNING Immediately after the engine is stopped, the oil and parts are at high temperature, and this will cause burns. Wait for the 3. Install cover (3) and nut (2). 4 - 60 7. Loosen wing nu Pump lever (5) until bubbles sto t (4) holding lever (5) of priming pump (3). up and down to carry out priming. Continue p coming out with the fuel from the hole for air bleed plug (2). 8. Tighten air blee priming pump (3 Tightening tor 7.8 to 9.8Nm{ Tightening tor 6.9 to 12.7Nm ding plug (2) and then tighten wing bolt (4) of ) securely to lock lever (5).
que for air bleeding plug 0.8 to 1kgm} que for wing screw {0.7 to 1.3kgm} he filter cartridge, start the engine and check 9. After replacing t eck that there is no leakage of fuel from the filter seal surfac e. If there is any lea kage of fuel, check t he tightening o f the f ilter cartridge. If ther e is still leakage of fu el, follow Step 1 and 2 to remove the filter cartridge, then chec k the packing s urface for damage or forei gn material. If any da mage or f oreig n material is found in the p acking, replace the c artridge w ith a new part, art, then repeat Step s 3 - 9 to install the f ilter cartridge. temperature to go dow n before starting the op 1.
Remove nut (2) of breather assembly (1) at th e top surfac e of the fuel tank, the n remove cover (3).