Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE WARNING the seal surface of the 4 - 61 Immediately after the eng ine is stopped, the oil and parts are at high temperature, so do not replac e the cartridge immediately. Wait for the parts to cool Prepare a filter wren ch and a container t o catch t he coolan 1. 2. 3. Turn valve (1) at th Place a container u Using a filter wrenc e top of the corrosio nder the cartridge t h, remove cartridge n resistor o catch th (2). Clean the filter hol cartridge with clean When installing, ti surface of the filter If the cartridge is tig der, coat the steel surface of engine oil, then install it.

ghten until the gasket cont head, then tighten a further 2 htened too far, the gasket will and this will lead t o leakage of water. If the ca rtridge is too loose, water will als o leak from the gap a t the gask et, so always tighten the correct 6. Turn valve (1) to o 7. After replacing the cartridge. If there i s any leakage of water, chec k the tightening condition of the cartri