Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE TRANSMISSION FILTER ELEMENT WARNING cause burns. Wait for the filter head, drain the oil, then seal surface of the new filter CASE, ADD OIL (PAGE 3-74)". the oil, then tighten the plug the inside of the filter case, filter case, and the parts that "CHECK OIL LEVEL IN bleeder screw (3), then insert a screw (3) approx. 3/4 turns, transmission case is up to the REMARK 4 - 62 The parts and oil are at high tem perature immediately after the engine is stopped, and may ting the work. rn it slowly to release the internal pressure, then remove it.

temperature to go down before star When removing the oil filler cap, tu VALVE SIDE Prepare a filter wrench and a c 1. Place a container under the fil 2. Remove drain plug (1) at the tighten the plug again. Using a filter wrench, turn filter it. 3. 4. Clean the filter head, coat th cartridge thinly with clean oil, Tightening torque: 49 to 59 N 5. Add oil. For details, see "CHE BRAKE COOLING SIDE 1. 2. Remove bolt (1), then remove Place a container immediately oil. Remove drain plug (P), drai again. Remove the element, then w 3. the strainer at the bottom of t were removed. 4. Install the new element, then i 5. Add oil. For details, se TRANSMISSION CASE, ADD 6.

Remove the cap installed to vinyl hose. Prepare a containe end of the hose approx. 50 mm oil. (Use any commercially av 7. Start the engine, loosen blee and keep the engine running a out from the vinyl hose. 8. Tighten bleeder screw (3) pro 9. Check that the oil level in the specified level. If the oil level is low, add oil. 10. When the air is bled from inside th e case, the transmission oil level