. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4. Place a container immediately under filter case (1), then remove filter case (1). add 80 liters (21.14 US gal) of oil will temporarily go above the oil but this does not indicate any 8. Start the engine and run at low idling. NOTICE 4 - 64 5. Take out the element and wash the i nside of the f ilter cas e. Replace O-ring (2) and b ackup ring (3) on the filt with new parts , coat thinly with clean oil, t hen in 6. Assemble a new element in the filter case the eleme nt thinly with cle an oil, then insta Tightenin g torque: 78.4 to {8 to 10 k gm, 57.9 to 72.3 7. Before st arting the engin through o il filler port (F).
When oil is added, the le level on abnormal there is no oil i n the system, it wil l cause damage to the transmission and hydraulic pump . 9. Add oil th rough oil filler po rt (F) until the oil level is betwee n the H and L marks on sight