Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE hose approx. 50 mm into a come out from the vinyl tighten bleeder screw (1) Center brake:See "BLEED AIR FROM CENTER BRAKE (PAGE 4-33)". NOTICE damage to the pump. LEVEL IN TRANSMISSION CASE, ADD OIL (PAGE 3-74)". 4 - 65 When running the engine at low idling , be careful not to let the oil level in the brake oil tank go below sight gauge (H). If t he oil level goes below sight gaug e (H), stop the engine to raise the oil level in the br 10. Remove the cap from bleeder scre (Use a commercially available vin 11. Put the other end of the vinyl h container of oil. 12. Loosen bleeder screw (1) approx. at low idling until no more bubb hose.

When no more bubbles come o 13. securely, remove the vinyl hose, 14. Carry out the warming-up operati on of the engine until the torque converter oil temp erature gauge goes above 40°. 15. When the torque converter oil tem perature gauge rises to 40 Front brake:See "BLEED AIR FR Do not re-use the oil drained when blee Be careful not to let the oil level in the brake oil tank go below sight gauge (H) during the air ble ed operation. This will cause 16. After completely bleeding the air f rom the brakes, stop the engine for approx. 2 - 3 mi nutes. After that, check the oil level in the transmission case