. MAINTENANCE SERVICE PROCEDURE CHECK WEAR OF BRAKE DISC WARNING 3. Remove cap nut (1). 4. Depress the brake pedal, keep it depressed, and push in rod (2) of the gauge until it contacts the piston. 5. If mark (3) at position "A" of rod (2) enters beyond guide end face (4), it means that the disc has reached the wear limit. For the front brake, use the mark at position "A", and for the center brake, use the mark at position "B". If the disc has reached the wear limit, please contact your Komatsu distributor for inspection and maintenance. 6. Tighten cap nut (1) removed in Step 3. Tightening torque:
14.7 to 19.6 Nm (1.5 to 2.0 kgm, 10.8 to 14.5 lbft) 4 - 68 Carry out this check when the b rake oil temperature is below 60°C (140°F). I f the disc wear approaches the wear limit, check the condition frequently, regardless of the maintena nce interval. In addition, check the retarder capacity car efully. 1. Stop the machine on level ground, set the parking brake switch to the PARKING position, then check that the d before starting inspection. and check that the retarder oil pressure caution lamp is out. n, then check that the other brakes are not applie 2. Turn the starting switch ON and check that the retarder oil pressure caution lamp is out.
If the retarder oil pressure c goes out, turn the starting aution lamp is lighted up, start the engine, run the engine at 200 0 rpm, and if the lamp REMARK With new machines, the pos ition of the guide is adjusted so that mark (5) comes to end fa ce (4) of the guide, so do not loosen locknut (6) ex cept when replacing the disc. two workers. One worker depresses the brake pedal and the other pushes in the Carry out the operation with two workers. One worker depresses the brake pedal and th rod. If the rod is pushed in when the engine is running, the rod will be pushed back by the brak e cooling oil pressure, so always carry out this ope ration with the engine stopped.
There are marks on the rod at three places (A, B, C), but for the front brake, use the mark a t position "A", and for the center brake, use the m ark at position "B".